Automatic transmission cushions and audi b3 mechanics are exactly the same, and the method of removing and replacing them does not depend on the type of box and year of manufacture.Am very glad to share this testimony with everyone for the marvelous work Dr LOSA has done for my life, 6 months ago i was diagnosed with herpes virus and ever since then i have been very unhappy, i was so down broken everyday, until one day when i came across a shocking testimony about how Dr LOSA cured someone of his herpes virus, without wasting much time i contacted him immediately on his email address: and after i explain myself to him about how terrible i have been, and he assure me that he will help me to cure my herpes. Repairing a pillow with improvised means takes even an inexperienced driver no more than 30 minutes.

Then you need to remove the pillow and replace it with a new one.

The support is retracted and 2 bolts holding the pillow are unscrewed.

The subframe bolt is slightly loosened, which will allow the pillow support to move freely.

We unscrew the central bolt of the pillow.

Using a jack, the gearbox is slightly raised.

Replacing the box cushion with an Audi 80 b3 is not too difficult in itself, especially if you find out the sequence of actions before starting the repair. To check, turn on reverse gear and accelerate the car in this case, the vibrations of the engine and mechanics will be as strong as possible, which excludes all other possible malfunctions. Strong vibrations during the operation of the Audi b3 and b4 engine while driving can lead to failure of the pillows.

After the cleaning process, you can install and check the performance of the repaired audi 80 v3 and b4 sensor. Often the spring that pushes the barrel 'gets tired' and needs to be stretched a little for normal operation. The reverse sensor is attached to the gearbox with a 13 bolt holding its plate and two more, which need an asterisk to unscrew.Īfter removal and disassembly, the mechanics speed sensor is thoroughly washed and all contacts are cleaned. The hole at the bottom provides the car owner with access for repairs. To access it, remove the battery and the rubber gasket on them. The reverse button on the audi 80 v3 mechanics is installed on the right side under the battery.

Usually its repair consists in a thorough cleaning of the contacts and terminals, which takes a lot of time. The cost of a new part is often the reason that the driver ignores this malfunction, but not in all cases the reverse sensor dies irrevocably. The speedometer needle after a simple repair should move smoothly and without jerks. After disassembling and thoroughly cleaning it from dirt and removing the plate from the contacts, you can install the sensor in its original place and continue checking its performance.

Ne rabotaet tahometr na audi 80 v3